A full attic reset after leaks, pests, smoke or old repairs: debris removed, surfaces cleaned and the space ready for new insulation.
Over decades, an attic collects more than insulation. Old wiring scraps, leftover building materials, dust, nesting material and failed patches all pile up. After a roof leak, a pest problem or a fire, that debris can hide moisture and odors.
We clear the attic floor, vacuum out contaminated material, remove debris and clean framing surfaces with HEPA vacuums, then document what we found. From there, we air seal, repair what needs repair and install new insulation, giving you an attic that is clean and efficient.
After pests, roof leaks, smoke or a renovation, a thorough cleanup removes the sources of odor and contamination. It is also helpful before selling a home.
Fine dust and fibers spread easily. HEPA-filtered vacuums capture particles and leave framing and sheathing clean and visible.
With the debris gone we can see stains, rot or damaged framing. We flag them, photograph them and suggest the right trade.
A clean attic is the right place to start air sealing and new insulation. The finished layer sits on a clean, sealed floor.
Drag the handle to compare.
BeforeAfterOld materials and clutter cleared.
Hidden problems exposed.
Dust captured, not spread.
Waste removed from the property.
Before and after photos.
Air sealed and refilled.
Every topic has its own page with what to expect and how we approach it.
Project situationOlder HomesOlder houses have charm and hidden challenges, from empty walls to unsealed attics. Here is how to improve…Learn more 
Project situationHigh Energy BillsWhen bills climb and the house still does not feel right, the building is often the reason. Here…Learn more 
Material guideCelluloseRecycled paper fiber, treated for fire and pests, installed loose or dense-packed. Here is where it shines.Learn more Enter the attic size, the material and the depth you have now to see how much to add to reach your target.
You tell us what is going on, which rooms bother you and what you hope to change, and we set a time that fits your day.
We walk the attic, walls, crawl space and equipment, measure depths and use thermal imaging when it helps.
We protect the house, seal air leaks, place baffles and fix small problems so the insulation can do its job.
Loose-fill, batts, foam or board goes in to the planned depth, with clean edges and clear markers.
We measure the result, take photos and test air leakage when the scope includes it.
We walk the finished work with you, answer questions and leave the site clean.
Not always, but it is the right step when material is wet, contaminated or full of debris.
Cleaning and removing affected insulation helps a great deal. Persistent odor may also need sealing or other treatments.
We can move them aside and put them back. We do not haul your belongings without permission.
We stop, document it and recommend a remediation specialist before any new insulation goes in.
Most attics take one to two days, depending on size and debris.
Attic Removal and ReplacementOld, wet, matted or contaminated insulation removed by vacuum and replaced with a clean, correctly sized layer.Explore 
Rodent Cleanup and ReinsulationContaminated insulation removed, nests and droppings cleaned and entry points flagged, then replaced with fresh, protected insulation.Explore 
Vermiculite and Old InsulationCareful identification of old loose-fill, with testing guidance and safe next steps if your attic has vermiculite or…Explore 
Blown-In Attic InsulationA deep, even blanket of loose-fill insulation over your ceiling, installed to a measured depth so every room…Explore Tell us about the project and we will call you back to talk it through.
Or call (615) 357-7797 to talk now.
